Home / Services
Datasheet · Services
Five service lines, one senior engineer.
Engage us for a single stage or the whole path from schematic to a documented, manufacturable design. Every line below is delivered directly by the founder.
Service · 01
PCB layout design
The board is where an idea becomes physical — and where most hardware problems are quietly created or avoided. We lay out multi-layer PCBs with manufacturability, signal integrity and thermal behaviour treated as design goals from the first placement, not afterthoughts at bring-up.
- Component placement for signal flow, thermals and assembly
- Controlled-impedance and high-speed routing
- Power distribution, decoupling and ground strategy
- Design-for-manufacture and design-for-test from the start
| Typical inputs | Schematic, mechanical constraints, target stack-up |
|---|---|
| Deliverables | Layout database, Gerber/ODB++, drill files, assembly drawings |
| Best for | New boards, re-spins, dense or high-speed designs |
Service · 02
AI & edge-hardware consulting
Running intelligence at the edge is a hardware problem before it is a software one. We help you choose the MCU, SoC, accelerator, memory and sensor stack that will actually meet your latency, power and cost targets — and design the board around that decision rather than fighting it later.
- Processor, accelerator and sensor selection for edge inference
- Power and thermal budgeting for always-on workloads
- Trade-off analysis between performance, cost and board area
- Architecture guidance that keeps the software team unblocked
| Typical inputs | Workload, power envelope, cost target, form factor |
|---|---|
| Deliverables | Component recommendations, block architecture, trade-off notes |
| Best for | Smart devices, embedded AI, sensor-driven products |
Service · 03
Prototype-to-production support
A working prototype and a manufacturable product are not the same thing. We help close that gap: bringing boards up, diagnosing what the bench reveals, iterating deliberately, and preparing the design so a contract manufacturer can build it repeatably and at yield.
- Board bring-up and hands-on debugging
- Design iteration driven by measurement, not guesswork
- Test strategy and new-product-introduction planning
- A clean hand-off package to your manufacturer
| Typical inputs | Prototype boards, test goals, target volume |
|---|---|
| Deliverables | Bring-up report, iteration plan, test & NPI documentation |
| Best for | Teams moving from a proven prototype to volume production |
Service · 04
Design review & advisory
Sometimes you don't need us to do the design — you need a senior engineer to tell you the truth about it. A structured review of your schematic, layout or architecture catches the expensive mistakes while they are still cheap to fix, and gives your team an experienced sounding board.
- Schematic review — correctness, part choices, risk areas
- Layout review — signal integrity, power, manufacturability
- Architecture advisory — the big decisions, early
- Clear, prioritised findings your team can act on
| Typical inputs | Schematics, layout files, architecture docs |
|---|---|
| Deliverables | Prioritised findings report with recommended fixes |
| Best for | In-house teams wanting a senior second opinion before a re-spin |
Service · 05
Supplier coordination & documentation
A design is only as good as the package that leaves for the fab. We produce the clean, consistent documentation — BOMs, fabrication and assembly files, design notes — and coordinate with your suppliers so that what gets built matches what was designed.
- Accurate, sourced bills of materials (BOMs)
- Fabrication and assembly file packages
- Design notes that capture intent and rationale
- Direct coordination with fabricators and assemblers
| Typical inputs | Final design, preferred suppliers, volume targets |
|---|---|
| Deliverables | BOM, Gerber/ODB++, assembly docs, design notes |
| Best for | Getting a finished design cleanly into manufacturing |
Not sure where you fit?
Tell us the stage — we'll map the service.
Most engagements combine two or three of these lines. Describe your board and timeline and we'll propose the right scope.